Setting the PT-200E regulator
Adjusting the regulator
To change the regulation parameters, press the (RIGHT) key, then press (UP) or (DOWN) to select the parameter setting item (PARAM SETUP) and press (RIGHT). Then you need to enter the password 117 and press (RIGHT). The controller enters the parameter setting mode
|
Procedure for setting the lower and upper limits of the electric heating trigger temperature
|
1. Press repeatedly “UP” or “DOWN” to enter the mode for selecting the lower and upper limits of the electric heating triggering temperature (TEMPER1). 2. Use the (RIGHT) key to select the desired lower limit parameter (TEMP.MIN) and use the UP or DOWN keys to select the desired value, then press (RIGHT). The value of the lower limit is set 3. Using the (RIGHT) key select the required upper limit parameter (TEMP.MAX.) and using the “UP” or “DOWN” keys select the required value, press (RIGHT). The value of the upper limit is set 4. Return to the main menu by pressing (RESET)
|
|
Procedure for setting the operating time of the auxiliary electric heating in case the main electric heating is switched off (in case the ambient temperature exceeds the set limits or precipitation stops).
|
1. Press repeatedly “UP” or “DOWN” to enter the mode for selecting the operating time of the electric auxiliary heating (TIMER SETUP). 2. Use the (RIGHT) key to select the desired delay parameter (DELAY.) and use the UP or DOWN keys to select the desired value and press (RIGHT). The value of the supplementary heating time is set 3. Return to the main menu by pressing (RESET)
|
After finishing entering the parameters, exit to the main menu and wait until the backlight screen goes out, in this case the parameters will save the updated values
Adjusting the regulator
To change the regulation parameters, press the (RIGHT) key, then press (UP) or (DOWN) to select the parameter setting item (PARAM SETUP) and press (RIGHT). Then you need to enter the password 117 and press (RIGHT). The controller enters the parameter setting mode
|
Procedure for setting the lower and upper limits of the electric heating trigger temperature
|
1. Press repeatedly “UP” or “DOWN” to enter the mode for selecting the lower and upper limits of the electric heating triggering temperature (TEMPER1). 2. Use the (RIGHT) key to select the desired lower limit parameter (TEMP.MIN) and use the UP or DOWN keys to select the desired value, then press (RIGHT). The value of the lower limit is set 3. Using the (RIGHT) key select the required upper limit parameter (TEMP.MAX.) and using the “UP” or “DOWN” keys select the required value, press (RIGHT). The value of the upper limit is set 4. Return to the main menu by pressing (RESET)
|
|
Procedure for setting the operating time of the auxiliary electric heating in case the main electric heating is switched off (in case the ambient temperature exceeds the set limits or precipitation stops).
|
1. Press repeatedly “UP” or “DOWN” to enter the mode for selecting the operating time of the electric auxiliary heating (TIMER SETUP). 2. Use the (RIGHT) key to select the desired delay parameter (DELAY.) and use the UP or DOWN keys to select the desired value and press (RIGHT). The value of the supplementary heating time is set 3. Return to the main menu by pressing (RESET)
|
After finishing entering the parameters, exit to the main menu and wait until the backlight screen goes out, in this case the parameters will save the updated values
